3D Printed Throttle Body Mockup

I quickly modelled and 3D printed a 30mm Jenvey TB mockup to see if it could be used to improve the current injection system which may/may not have had fuelling distribution issues.

Added on the Intake pipe from the Intercooler on to see if it would clear bonnet clearance..


It didn’t..

As it turns out there must be less than 30mm clearance between the top hose and bonnet as with the extra part fitted the bonnet won’t close.

Guess I could try cutting down the top silicon pipe where it meets the top Jenvey TB, but it would be a tight fit, has potential though.